One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
A single-cable fix often means a second failure soon after. We explain the pair-replacement logic upfront.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
This repair sits close to stored spring energy, which is exactly why licensed handling matters here too.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
We verify the door hangs and travels evenly before calling the repair complete.
“Door was hanging at an angle after a cable snapped. They replaced both cables and it's perfectly level now.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
This almost always means one lift cable or spring has failed while the other side is still holding weight.
Replacing just one often leads to a second failure soon after. We're upfront about that tradeoff.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
Most cable replacements are completed same-day, typically within one to two hours once the technician arrives.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Francis to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Francis, UT